XES Synergix 8825/8830/8850/8855 & X2-TECH System Introduction 57
SCSI Device Error Codes Chart
SCSI Sense Key Description /Action
01 RECOVERED ERROR. Indicates that the last command completed successfully with some
recovery action performed by the target.
Action: This error may be logged infrequently. Frequent occurrence indicates that the disk
drive should be replaced. Call for Service.
03 MEDIUM ERROR. Indicates that the command terminated with a non-recovered error
condition that was probably caused by a flaw in the medium or an error in the recorded
data.
Action: Call for Service.
04 HARDWARE ERROR. Indicates that the target detected a non-recoverable hardware
failure (for example, controller failure, device failure, parity error, etc.) while performing the
command or during a self test.
Action: Call for Service.
05 ILLEGAL REQUEST. Indicates that there was an illegal parameter in the command
descriptor block or in the additional parameters supplied as data for some commands.
Action: Call for Service.
?? Action: Call for Service.
To Next Page
Loading...
Need help?
General