Printing
ColorQube 8570/8870 Color Printer
User Guide
79
5. On the printer control panel:
a. Select Paper Tray Setup and then press the OK button.
b. Select the tray you are using: Tray 2 Paper Type, Tray 3 Paper Type, Tray 4 Paper Type, or
Tray 5 Paper Type.
c. Press OK.
d. Select Glossy Paper as the paper type and then press OK.
6. In the printer driver, select Glossy Paper as the paper type, or select the tray you are using as the
paper source.
Printing on Prepunched Paper
This section includes:
• Printing on Prepunched Paper from Tray 1 on page 79
• Printing on Prepunched Paper from Tray 2, 3, 4, or 5 on page 80
Use the same printing guidelines as for regular paper, except take care not to print over the holes.
Printing over the holes may cause ink to transfer onto subsequent pages.
Printing on Prepunched Paper from Tray 1
1. Open Tray 1 and its extension. For details, see Loading Paper in Tray 1 on page 56.
2. Insert the side to be printed facedown with the holes toward the right side of the tray as shown.
3. Adjust the print margins to accommodate the holes. A minimum margin of 19 mm (0.75 in.) is
recommended.
4. On the printer control panel, if the correct paper size and type are displayed as the current setup,
press the OK button. Go to step 6.
5. If the correct paper size and type are not displayed, do the following:
a. Select Change setup > OK.
b. At the Tray 1 Paper Size menu, select the paper size and then press OK.
c. At the Tray 1 Paper Type menu, select Prepunched > OK.
6. In the printer driver, select Prepunched as the paper type, or Tray 1 as the paper source.
To Next Page
Loading...
Need help?
General
