Scanning with the TWAIN Interface from PaperPort
94 DocuMate 252 Scanner User’s Guide
Setting Up PaperPort to Work With Your Scanner
When you select a scanning option from PaperPort’s Scanner
drop-down list, either Twain: Xerox DocuMate 252 or WIA: Xerox
DocuMate 252 (Windows XP only), the Scan button at the bottom
of the panel should become active. If it doesn’t you need to set up
PaperPort to work with your scanner.
NOTE: Setting up PaperPort is a one-time-only process for
each option from the Scanner drop-down list. Therefore, you
may have to set up PaperPort once each for Twain: Xerox
DocuMate 252 and WIA: Xerox DocuMate 252. The setup
process, described below, is the same for each option. You will
not have to set up PaperPort again for either option unless you
uninstall the scanner and PaperPort software, then re-install
them.
If this Scan button is not active, you need to set
up PaperPort to be able to access your scanner.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
