Xerox CopyCentre C20, WorkCentre M20 and WorkCentre M20i User Guide Page 2-13
Getting Started
USB or Parallel Port Cable
(WorkCentre M20 and M20i only)
#
Only connect one of the above cables. If you are using a USB cable, you must be running
Windows 95, 98, Me, 2000, XP or NT 4.0. When using the USB connection, your machine
provides two USB modes; Fast and Slow. Fast is the default mode. Some PC User’s may
experience poor functionality in the default mode. If this occurs, select the Slow mode. For
information about changing the USB mode, refer to “Machine Setup” on page 2-19.
3
CAUTION: Shut down the
computer before connecting the
cable.
! Connect the USB Cable which
came with your machine.
OR
! If you want to use a parallel print
cable, only use an IEEE-1284
compliant cable and connect it to
the parallel connector on your
machine.
To Next Page
Loading...
