Xerox Phaser 3428 - Setting Ethernet Speed; Restoring the Network Configuration; Printing a Network Configuration Page

4.3 < Network setup (Phaser 3428/DN only)>
Setting Ethernet speed
You can select the communication speed for Ethernet connections.
1 Press Menu until Network appears on the bottom line of the
display and press OK.
2 Press the Scroll buttons until Ethernet Speed appears and press
OK.
3 Press the Scroll buttons until the speed you want appears and
press OK.
4 Press Stop to return to Standby mode.
Restoring the network configuration
You can return the network configuration to its default settings.
1 Press Menu until Network appears on the bottom line of the
display and press OK.
2 Press the Scroll buttons until Clear Setting appears and press
OK.
3 Press OK when Yes appears to restore the network configuration.
4 Power the printer off and back on.
Printing a network configuration page
The network configuration page shows how the network interface card
on your printer is configured.
1 Press Menu until Network appears on the bottom line of the
display and press OK.
2 Press the Scroll buttons until Network Info. appears and press
OK.
3 Press OK when Yes appears.
The network configuration page prints out.