Safety
Phaser 6000/6010 Color Printer
User Guide
10
Operational Safety
Your printer and supplies were designed and tested to meet strict safety requirements. These include
safety agency examination, approval, and compliance with established environmental standards. Your
attention to the following safety guidelines helps to ensure the continued, safe operation of your
printer.
Operational Guidelines
• Do not remove the paper from the tray when the printer is printing.
• Do not open the doors when the printer is printing.
• Do not move the printer when it is printing.
• Keep hands, hair, neckties, and such, away from the exit and feed rollers.
• Covers, which require tools for removal, protect the hazard areas within the printer. Do not remove
the protective covers.
• Do not use conductive paper such as origami paper, carbonic paper, or conductively coated paper.
Ozone Release
This printer produces ozone during normal operation. The amount of ozone produced is dependent on
the volume of printing. Ozone is heavier than air and is not produced in amounts large enough to harm
anyone. Install the printer in a well-ventilated room.
For more information in the United States and Canada, go to:
• Phaser 6000 printer: www.xerox.com/environment
• Phaser 6010 printer: www.xerox.com/environment
In Europe, go to:
• Phaser 6000 printer: www.xerox.com/environment_europe
• Phaser 6010 printer: www.xerox.com/environment_europe
Printer Location
• Do not block or cover the slots or openings on the printer. These openings are provided for
ventilation and to prevent overheating of the printer.
• Place the printer in a dust-free area where there is adequate space for operation and servicing. For
details, see the Installation Guide.
• Do not store or operate the printer in extreme conditions of heat or humidity. For specifications on
optimum performance environment, see Clearance Requirements on page 65.
• Place the printer on a level, solid, non-vibrating surface with adequate strength to hold the weight
of the printer. The base printer weight without any packaging materials is approximately 10.7 Kg
(23.6 lb.).
• Do not place the printer near a heat source.
• Do not place the printer in direct sunlight to avoid exposure to light-sensitive components.
To Next Page
Need help?
General