Xerox PHASER 6130 - Page 89

Description of Menu Items
Phaser® 6130 Printer
5-8
USB Setup
Specifies the settings for USB.
Protocol Set Enable when using the protocol. When Disable is selected, the protocol
cannot be activated.
■ LPR (default: Enable)
■ Port 9100 (default: Enable)
■ IPP (default: Enable)
■ SMB TCP/IP (default: Enable)
■ SMB NetBEUI (default: Enable)
■ FTP (default: Enable)
■ NetWare (default: Enable)
■ SNMP (default: Enable)
■ Email Alerts (default: Enable)
■ CentreWare IS (default: Enable)
■ Bonjour (mDNS) (default: Enable)
■ HTTP-SSL/TLS (default: Enable)
IPP, NetWare, and HTTP-SSL/TLS are displayed only when the optional multi
protocol card is installed.
Host Access List Specifies blocking the reception of data from certain IP addresses.
Reset Defaults Initializes network data stored in NVM. The NVM is a nonvolatile memory that
stores the printer settings even after power off. Initializing the NVM will revert the
value for each item of the Wired Network menu to default.
Adobe Protocol
■ Auto (default)
■ Standard
■ BCP
■ TBCP
■ Binary
Item Description
Adobe Protocol
■ Auto (default)
■ Standard
■ BCP
■ TBCP
■ Binary
Item Description