Description of Menu Items
Phaser® 6130 Printer
5-9
System Setup
System Setup menu is used to make the printer operation settings, such as for alarm and power
saver mode.
Item Description
PowerSaver
Timer
Specify the transitional time to Power Saver between 5 and 60 minutes in
increments of 1 minute.
■ 5 min. to 60 min. (default: 30 min.)
■ For details, refer to Power Saver Mode on page 2-8
Audio Tone Specifies whether to turn on the alarm when an error occurs in the printer. You
cannot adjust the sound volume.
■ Control Panel (default: Off)
■ Invalid Key (default: Off)
■ Machine Ready (default: Off)
■ Job Complete (default: Off)
■ Fault Tone (default: Off)
■ Alert Tone (default: Off)
■ Out of Paper (default: Off)
■ Low Toner Alert (default: Off)
■ Base Tone (default: Off)
Time-Out You can cancel a printing process when it goes beyond a set time period. Set the
time until the print job is canceled. When this timeout expires, the print job is
canceled.
■ 5 sec. to 300 sec. (default: 30 sec.)
Specifies the amount of time in increments of 1 second the printer waits for
additional data before it cancels the job.
■ Off
Cannot cancel.
Panel Language Specifies the language that is displayed on the control panel and Information
pages.
Auto Log Print Specifies whether to automatically print information about the printed data that
has been processed in the printer (Job History Report).
■ Off (default)
Select this if you do not want to print the Job History Report automatically
even if the number of print jobs exceeds 22.
■ On
Automatically prints a report when the number of print jobs reaches 22.
■ You cannot set this during printing.
■ You can print the Job History Report from the Information Pgs menu.
■ You need to restart the printer to activate the new settings. After making the
settings, turn off the printer and then turn it on again.