Поиск и устр. неиспр.
Phaser 6700 Color Printer 115
Руководство пользователя
A system error occurred. Contact your Xerox
®
service representative with the error code and
message. Check the control panel fault history. For details, see
Viewing Error Messages on the Control Panel на стр. 140.
Printing Takes Too Long
Probable Causes Solutions
The printer is set to a slower printing mode,
for example, for printing on heavyweight
paper or transparencies.
It takes more time to print on certain types of special media. Make
sure that the paper type is set properly in the driver and at the
printer control panel.
The printer is in Energy Saver mode. Wait. It takes time for printing to start when the printer is coming
out of Energy Saver mode.
The way the printer was installed on the
network could be an issue.
Determine if a print spooler or a computer sharing the printer is
buffering all print jobs and then spooling them to the printer.
Spooling can slow print speeds. To test the speed of the printer,
print some Information pages such as the Office Demo Page. If the
page prints at the rated speed of the printer, you could have a
network or printer installation issue.
The job is complex. Wait. No action needed.
The print-quality mode in the driver is set to
Photo.
Change the print-quality mode in the print driver to Standard.
The printer quality is set to Photo and the
printer is being used for complex, 2-sided
print jobs.
Increase memory size to 2 GB RAM .
Document Prints From Wrong Tray
Probable Causes Solutions
Application and print driver have conflicting
tray selections.
1. Check the tray selected in the print driver.
2. Go to the page setup or printer settings of the application from
which you are printing.
3. Set the paper source to match the tray selected in the print
driver or set the paper source to Automatically Select.
Примечание. Set the paper source tray selection to Auto Selection
Enabled to have the print driver select the tray.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
