Enabling Upgrades
1. In the Embedded Web Server, click System.
2. Click Software Update.
3. If the Software Update area shows Disable, click Enable.
Note:
Changing this state requires a restart.
Procedures
Select a method to upgrade the device firmware.
Method 1: Upgrade using the Embedded Web
Server
1. At the printer control panel, print a copy of the
Configuration Report: see page 1 for instructions.
2. In the Embedded Web Server, log in as Admin, then click
System.
3. Click Software Update.
4. In the Software Update area, click Check Now.
5. Click Install Now.
Note:
If Check Now fails, set up the proxy server. Refer to the System Administrator Guide for instructions or follow the instructions for
Upgrade Software Manually, below.
Method 2: Upgrade Firmware Manually
1. At the printer control panel, print a copy of the
Configuration Report: see page 1 for instructions.
2. At the computer, access www.xerox.com/support
. Locate
and download the latest software release .zip file for your
product. Unzip the file to your desktop.
3. Open an Internet browser window. Enter the IP Address of
the device in the Address field in the format
http://xxx.xxx.xxx.xxx then press Enter.
4. Log in as Admin, then click System. The default password
is 1111.
5. Click Software Update.
6. In the Update from File Specified section, click Select.
7. Browse and select the downloaded .bin file from your desktop.
8. Click Install Now.