xFusion Digital Technologies FusionServer 1288H V7 - Page 41

Configuration Front Drive Rear Drive Drive
Management
Mode
10 x 2.5" drive
pass-through
configuration 3
● Front drive (10
x 2.5"):
– Slots 0 to 9
support only
SAS/SATA
drives.
● I/O module 1 (2
x 2.5")
a
:
– Slots 12 and
13 support
only SAS/
SATA drives.
● 1 x PCIe RAID
controller card
– When I/O
module 1 is
configured
with drives,
the PCIe
RAID
controller
card is
configured
in slot 3.
– When I/O
module 1 is
not
configured
with drives,
the PCIe
RAID
controller
card is
configured
in slot 1.
● a: I/O module 1 (2 x 2.5") is configured with 2 x 2.5" rear drives and PCIe riser
modules.
For details about the optional components, consult the local sales representative or
see "OS and Parts Compatibility" in the Compatibility Checker.
Drive Numbering
NO TICE
The drive numbers identified by the RAID controller card vary depending on the
cabling of the RAID controller card. This section uses the drive numbers identified by
a RAID controller card that adopts the default cabling described in "Internal Cabling"
in the FusionServer 1288H V7 Server Maintenance and Service Guide.
● Drive numbers of the 10 x 2.5" drive pass-through configuration 1 in Table 5-13.
Figure 5-22 Drive numbering
FusionServer 1288H V7 Server
Technical White Paper 5 Hardware Description
Issue 02 (2023-05-25) Copyright © xFusion Digital Technologies Co., Ltd. 34