Chapter3. Installation of Accessories
Before the radio is ready for use we need to attach the antenna and battery pack, as well as charge the battery.
3.1 Installing/ Removing the Antenna
a. Installing: Align the antenna with the antenna port. Rotate the antenna clockwise until it is fully tightened and secured in place.
b. Removing: Rotate the antenna counterclockwise until it is completely detached from the port.
NOTICE:
When removing the battery, ensure that the radio is turned off.
3.2 Installing the belt clip
a. Align the grooves of the belt clip with those of the radio and push down until you hear a click.
b. To remove the clip, use a flatbladed object to press the belt clip tab away from the radio. Then, slide the clip upward and away from the radio.
3.3 Installing the battery pack
Before attaching or removing the battery make sure your radio is turned off by turning the power/volume knob all the way counter-clockwise.
a. Make sure the battery is aligned in parallel with the radio body with the lower edge of the battery about 1-2cm below the edge of the radio.
b. Once aligned with the guide-rails, slide the battery upward until you hear a click as the battery locks in place.
Remove the battery pack
To remove the battery, press the battery release above the battery pack, as you slide the battery downward.
3.4 Installing the Additional Speaker/Microphone (Optional)
Pry open the rubber MIC-Headset jack cover and then insert the Speaker / Microphone plug into the double jack.
To Next Page
Loading...