b. To cancel your changes, press [EXIT] and it will reset that menu item and bring you out of the menu entirely.
6. To exit out of the menu at any time, press the [EXIT] key.
7. All further examples and procedures in this manual will use the numerical menu shortcuts.
6.2 Scanning
The Radios features a built in scanner for the VHF and UHF bands. When in Frequency (VFO) mode it will scan in steps according to your set
frequency step. In Channel (MR) mode it will scan your channels. At approximately three frequencies per second, it's not the fastest scanner in
the world, but it is nonetheless a useful feature to have at times.
Dual Watch is inhibited while scanning
To enable the scanner, press and hold the
key for about two seconds. Press and hold the key to exit scanning mode.
6.2.1 Scanning modes
The scanner is configurable to one of three ways of operation: Time, carrier or search, each of which is explained in further details in their
respective section below.
Setting scanner mode
1. Press the [MENU] key to enter the menu.
2. Enter 1 9 on your numeric keypad to come to scanner mode.
3. Press the [MENU] key to select.
4. Use the
/ keys to select scanning mode.
5. Press the [MENU] key to confirm and save.
6. Press the [EXIT] key to exit the menu.
• Time operation
In Time Operation (TO) mode, the scanner stops when it detects a signal, and after a factory preset time out, it resumes scanning.
• Carrier operation
In Carrier Operation (CO) mode, the scanner stops when it detects a signal, and after a factory preset time with no signal it resumes scanning.
• Search operation
In Search Operation (SE) mode, the scanner stops when it detects a signal.
To resume scanning you must press and hold the
key again.
6.2.2 Frequency scanning
This function can scan the frequency.
To Next Page
Loading...