14
Mopping
Before starting, ensure the mop assembly and other necessary parts have been
installed onto the robot vacuum and the clean water tank has been added water.
Select the mopping mode in the app, and use the app or press the button on the
robot vacuum to start cleaning. Then the robot vacuum will automatically moisten
the mop pads first and leave the omni station to start mopping. Once it finishes
mopping, it will return to the omni station to wash and air-dry the mop pads.
More App Functions
Map settings
The homepage of the app displays the current map used for vacuuming and
mopping. You can set areas to avoid in the settings for restricted areas and edit
the current map in map management.
Cleaning settings
In the cleaning settings, you can adjust the cleaning mode, the suction level, and
the water flow rate based on the dirtiness of the floor and specific needs.
Omni station settings
The dust emptying and the mop pad cleaning can be configured in the omni
station settings.
In the dust emptying settings, you can enable or disable the function of auto
dust emptying and change its frequency.
In the mop pad cleaning settings, you can adjust the frequency at which the
robot vacuum returns to the station for cleaning mop pads.
Updating the Firmware
Restoring Factory Settings
Restarting the Robot Vacuum
You can update the robot vacuum's firmware via the Mi Home/Xiaomi Home
app. Before updating, make sure the robot vacuum is on the omni station and its
battery level is more than 15%.
If the robot vacuum does not function properly after being restarted, you can use
a pin to press the reset button for three seconds until you hear a voice to indicate
that the robot vacuum is restoring factory settings. This will reset the robot
vacuum to its original factory settings.
If the robot vacuum stops responding or cannot be turned off, press and hold the
button for 15 seconds to forcefully turn it off. Then press and hold the button
for three seconds to turn the robot vacuum on.
Notes:
· Before using the selected area/zoned cleanup or editing the map, a map needs to be created.
· Please refer to the app for more functions. Details of each function are subject to the app.
To Next Page