15
Care & Maintenance
Parts
To keep the robot vacuum in good condition, it is recommended to refer to the following table for routine maintenance.
Notes:
· The replacement frequency is for reference only. If a part is damaged, it should be replaced
promptly to ensure efficient cleaning.
· To move or ship the robot vacuum, please empty the clean and dirty water tanks to avoid the
robot vacuum getting damaged in transit.
Part Cleaning Frequency Replacement Frequency
Dust Compartment Clean as required /
Filter (Pre-installed on
the dust compartment)
Clean every two weeks 3–6 months
Clean Water Tank Clean every two weeks
/Dirty Water Tank
Recommended to clean
after each use
Washboard Clean every 1–2 weeks
Brush Clean every two weeks 6–12 months
Side Brush Clean every two weeks 3–6 months
Mop Pad / 1–3 months
Caster Wheel
Clean every month /LDS Laser Sensor
Line Laser Sensor
Part Cleaning Frequency Replacement Frequency
Cliff Sensor
Clean every month /
Robot vacuum's
charging contacts
Bumper
Auto-empty vents of
robot vacuum
Bottom of the robot
vacuum
Omni station
Omni station's charging
contacts
Omni station's signaling
area
Disposable bag /
Replace about every 2.5
months depending on
actual use
To Next Page