18
Brush Cover
Brush Cover Clips
Brush
Brush Bearings
CAUTION: If too much hair is tangled in the brush, or if the hair is tightly tangled, do not
forcibly pull on it, as this could damage the brush.
Cleaning the brush and side brush
1. Flip the robot vacuum over and pinch the clips to remove the brush cover.
2. Lift the brush out, remove the bearings on both ends, and clean the brush's axle.
3. Use scissors to cut any hair tangled around the brush, and remove any debris.
4. Pull out the side brush upwards and clean it.
5. Reinstall the side brush, brush and brush cover, and ensure they are securely in place.
Cleaning the caster wheel
1. Flip the robot vacuum over and pull out the caster wheel.
2. Remove hair, dirt, and other debris from the wheel and axle.
3. Reinsert the caster wheel and press it firmly back into place.
Notes:
· A small screwdriver or other pry tool can be used to gently pop out and remove the wheel.
· The wheel can be cleaned with water and reinstalled after drying.
Wheel
Axle
Clean the charging contacts, the auto-empty vents, and the signaling area of
the omni station with a soft, dry cloth.
Cleaning the omni station
Battery
The robot vacuum contains a high-performance lithium-ion battery pack. Please
ensure that it remains well-charged during daily use to maintain optimal battery
performance.
Note: If the robot vacuum is not used for an extended period, turn it off and put it away. To
prevent damage from over-discharging, the robot vacuum should be recharged at least once
every three months.
To Next Page