13
Care & Maintenance
Sensors and Charging Contacts * It is recommended to clean every month. Brush * It is recommended to clean every two weeks.
Use a soft cloth to clean all sensors and chraging contacts in the robot vacuum:
· Cliff sensors, charging contacts and ultrasonic sensor on the bottom of the robot
vacuum
· The LDS laser sensor on the top of the robot vacuum
· The bumper and the line laser sensors on the front of the robot vacuum
· The edge sensor on the side of the robot vacuum
Brush Cover
Clip
Brush
1. Flip the robot vacuum over and pinch the clips to remove the brush cover.
2. Remove the brush by pulling it upwards.
3. Pull out both brush end caps, use scissors to cut any hair tangled around the
brush, and remove any debris.
4. Reinstall the brush and the brush cover, and ensure they are securely in place.
Note: It is recommended to replace the brush every 6–12 months for optimal cleaning
performance.
Brush End Cap
CAUTION: If too much hair is tangled in the brush, or if the hair is tightly tangled, do not forcibly
pull on it to avoid damaging the brush.
LDS Laser Sensor Cover
LDS Laser Sensor
Line Laser Sensor
Bumper
Edge Sensor
Charging Contact
Cliff Sensor
Ultrasonic Sensor
To Next Page
Loading...
