04
· When removing the batteries from the product, it is better to use up the batteries and make sure your product is
disconnected from power.
1). Uninstall the screw on the bottom, then remove the cover.
2). Unplug the battery connector, then remove the batteries. Do not damage the battery case to avoid any risk of
injuries.
3). Return the batteries to a professional recycling organization.
– The battery must be removed from the appliance before it is scrapped.
– The appliance must be disconnected from the supply mains when removing the battery.
– The battery is to be disposed of safely.
EU Declaration of Conformity
Xiaomi Communications Co., Ltd. declares that the radio equipment type B108GL is in compliance with Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address: http://www.mi.com/global/service/support/declaration.html
For detailed e-manual, please go to www.mi.com/global/service/userguide
The product does not have a standby mode or other equivalent state in terms of energy efficiency requirements or power management function, the power
consumption of the product is likely to be higher than other products meeting these functional requirements.
Before use, read the instructions.
Laser Safety Information
The laser sensor in this product meets the IEC 60825-1: 2014 and EN 60825-1:2014/A11:2021 Standard for
Class 1 laser products. Please avoid direct eye contact with it during use.
CLASS 1 LASER PRODUCT
CONSUMER LASER PRODUCT
EN 50689:2021
For indoor use only
To Next Page
Loading...
