Xicom XT-50 - Default Chapter; Table of Contents

XT-50, XT-80, and XT-100 Amplifiers iii
TABLE OF CONTENTS
1. General Description............................................................................................ 1-1
Overview ............................................................................................................... 1-1
Control and Status Interface................................................................................ 1-2
Performance Specifications.................................................................................. 1-2
2. Installation............................................................................................................ 2-1
Introduction........................................................................................................... 2-1
Unpacking and Inspection................................................................................... 2-1
Mechanical Installation........................................................................................ 2-1
Waveguide Connection.............................................................................. 2-2
Air Ducting.................................................................................................. 2-3
Prime Power Connections ................................................................................... 2-3
AC Prime Power, 100 to 260 VAC, Single Phase.............................................. 2-3
Fuses ...................................................................................................................... 2-4
Controller Connections........................................................................................ 2-4
Control and Monitor Interfaces........................................................................... 2-5
Control Interfaces.................................................................................................. 2-6
Digital Status Circuits........................................................................................... 2-9
Analog Status Circuits........................................................................................ 2-11
Output Voltage Circuits..................................................................................... 2-11
Detected Power Calibration.............................................................................. 2-13
Standard Interconnect Cable............................................................................. 2-13
RF Connectors..................................................................................................... 2-16
3. Operation.............................................................................................................. 3-1
General ............................................................................................................. 3-1
Operating Modes.................................................................................................. 3-1
Heater Delay Mode............................................................................................... 3-1
Heater Standby Mode.......................................................................................... 3-1
Standby Mode....................................................................................................... 3-2
High Voltage ON Mode....................................................................................... 3-2
Fault Mode............................................................................................................. 3-2
Clearing Faults...................................................................................................... 3-3
Control and Status Signals................................................................................... 3-3
Control Signals...................................................................................................... 3-3
Status, Digital........................................................................................................ 3-3
Status, Analog ....................................................................................................... 3-4
Initial Turn-On...................................................................................................... 3-5
Pre-Power Check................................................................................................... 3-5
Turn-On Sequence................................................................................................ 3-5
Turn-Off ............................................................................................................. 3-6