The internal speed command S-shaped curve filtering function is added, and the parameter P3-11 is
added.
Add Z-phase output function of multiturn motors
Add parameter P8-25. When powered on, the panel directly displays speed or torque feedback
according to group P parameter settings:
P8-2 = 0: normal display, as before, power on to display 'BB' or 'run', the default setting;
P8-2 = 1: power on the panel to display the value of U0-00, speed feedback, unit: rpm;
P8-2 = 2: the value of U0-07 displayed on the panel when powered on, torque feedback, unit%;
123