Xinje DS5L Series Manual

1 E-121
Abnormal Zero Value
of U Phase Current
Sampling
Current Sensor Damage
or External Interference
too serious
Check whether grounding is
normal or not. If alarm cannot be
ruled out, please contact the agent
or manufacturer.
2 E-122
Abnormal Zero Value
of V Phase Current
Sampling
Current Sensor Damage
or External Interference
too serious
Check whether grounding is
normal or not. If alarm cannot be
ruled out, please contact the agent
or manufacturer.
13 0 E-150
Power cable
disconnection
Any phase in UVW of
driver, cable or motor
broken
Disconnect the power supply of the
driver and check the connection of
the power cable. It is suggested that
the multimeter be used to test the
condition. After eliminating the
errors, the driver should be re-
energized.
16 1 E-161 Driver thermal power
overload
Not match the motor
code
Check if the driver P0-33 is
identical with the motor code of the
motor label (the number after
MOTOR CODE), if not, please
change to the same one, then power
on again.
Overload, the actual
operating torque
exceeds the rated torque,
and continuous
operation for a long
time. (Monitor U0-02 to
check the actual
operating torque. If the
motor is in normal
operation, it will not jam
or jitter. If the U0-02 is
longer than 100, it will
Increase the capacity of drivers and
motors. Extend the acceleration and
deceleration time and reduce the
load. Monitor the U-00, whether it
is running over speed.
81

Xinje DS5L Series Specifications

General

Brand	Xinje
Model	DS5L Series
Category	Servo Drives
Language	English