Wireless Access Point
Configuring the Wireless AP 165
c. IP Settings: If you choose the Static IP addressing option, enter the
following:
• Address: Enter a valid IP address for this AP. To use a remote
connection (Web, SNMP, or SSH), a valid IP address must be
used.
• Subnet Mask: Enter a valid IP address for the subnet mask (the
default is 255.255.255.0). The subnet mask defines the number of
IP addresses that are available on the routed subnet where the AP
is located.
• Default Gateway: Enter a valid IP address for the default
gateway. This is the IP address of the router that the AP uses to
forward data to other networks.
• Click the Apply button for this interface when done making IP
changes.
4. SSID Settings: This section specifies the wireless network name and
security settings.
a. SSID Name is a unique name that identifies a wireless network. The
default SSID is xirrus. Entering a value in this field will replace the
this default SSID with the new name.
For additional information about SSIDs, go to the Multiple SSIDs
section of “Frequently Asked Questions” on page 520.
b. Wireless Security: Select the desired wireless security scheme (Open,
WEP or WPA). Make your selection from the choices available in the
pull-down list.
• Open — This option offers no data encryption and is not
recommended, though you might choose this option if clients are
required to use a VPN connection through a secure SSH utility,
like PuTTy.
For improved security, you should also take the additional steps described in
“Securing Low Level Access to the AP” on page 82.
To Next Page
Loading...
