LINE
#3
~L1NE#2
11'11'
LINE
#1
PAIRING
YOUR
BLUETOOTH
ENABLED
CELL
PHONE
TO
THE
XlINK
Each
XLink ITC-BTIN can be paired
to
three different cell
phones, one for each line.
To
pair a Bluetooth cell phone
to
a line perform
the
following
steps:
1.
Press
and hold one
of
the
three line buttons on the
XLink ITC-BTIN
until
it
flashes rapidly (keep
button
pressed for approximately 4 seconds).
2.
Put your cell phone
into
the
mode where
it
searches for
Bluetooth devices (similar
to
searching for a Bluetooth car kit). This may be found in
your cell phone's menu under'Tools;'Setup;
'Bluetooth'
and/or'
Connections' menu.
If
given
the
choice, search for'Handsfree' devices and select "Look for Devices". Your
cell phone should
then
scan/search for Bluetooth devices
3.
When the XLink
is
found XLink will be displayed on your
cell
phone's
LCD.
Accept this
device.
In
order
to
accept, your cell phone may
ask
you to do
so
by pressing any number
of
selections including;'select;'bond;'pair:
'yes:
'ok:
etc.
4.
Enter the
pass
code: 1 2 3 4
5.
Once
the
pairing
is
complete,
the
selected line's blue
light
button
on the XLink will
stop flashing quickly and remain solid.
Once paired, the XLink will remember
the
cell phone. Automatic connecting occurs
whenever the cell
phone
is
within
range (approx. 30ft.)
of
your XLink.
6
To Next Page
Loading...
Need help?
General
