Xlink ITC-BTTN User Manual

10
BLUE Slow Flash
Indicates the selected line is paired but the cell phone is currently out of range and/or
temporarily not connected. XLink is actively searching for this cell phone.
BLUE Off
Indicates the selected line is not paired or not searching for a cell phone (Manual
Connection Mode).
USING THE XLINK
To use the XLink connect your normal corded or cordless telephone into the connector
on the XLink with a standard telephone cable. This phone is now your extension .
telephone.
To use your telephone service line, connect the telephone service line to
the designated connection on the XLink (see page 4 for Connection Diagram).
PLACING A CALL
XLink ITC -BTTN is designed to work with your standard phoneand yourtelephone service
orindependently
of yourtelephone service. If you have connected your telephone service
line
to the XLink you will dial out directly bysimply picking up the phone and dialing. If you
wish
to dial out on yourcell phone simply select the appropriate line,"one""two"or"three" by
pressing OJI FLASH I [lJ1 FLASH Iori1)IFLASH ~ccordingly and dial the desired number.
To place a call on any telephone connected to the XLink, simply pick up the handset
and dial the number. When dialing
out using a cellphone connected to the XLink, an optional
[!Jdigit may be dialed at the end of the number to activate dialing immediately, the same as

Xlink ITC-BTTN Specifications

General

Brand	Xlink
Model	ITC-BTTN
Category	Gateway
Language	English