the
Send
button on the
cell
phone. Dialing a
[!]
is
not
required.The dialing process will start
following a short delay after the last digit
is
dialed.
After
picking
up
a
telephone
connected
to
the
XLink, you should hear a steady dial
tone,
if
you hear an error
tone
(series
of
rapid beeps), there are
no
lines available for an
outgoing
call. In this
case,
check
to
ensure
that
you have
at
least
one
cell
phone
paired
and connected
to
the
XLink. Also check
that
the
telephone
service line
is
connected
properl.y
to
the
XLink.
SELECTING LINE
If connected
to
the telephone service line (land line) the XLink will dial out from
the regular phone using the land line. You can choose
to
dial out using a cell
phone
by
selecting the appropriate line that is paired
to
the cell phone you wish
to
dial
out
on.
A specific line can be specified on a per call basis
by
first dialing the desired line
number and then pressing the IFLASHIkey on your telephone.
Example:
To
specify line 3 for an outgoing call, dial [illIFLASHI, then dial the
intended phone number.
If the XLink is not connected
to
the telephone service line (land line), the XLink
uses the lowest line number with a connected (paired) cell phone
for
outgoing
calls. For example, if cell phones for lines 2 and 3 are connected, all outgoing
calls will be made on line 2.
Anytime a rapid series
of
beeps
is
heard instead
of
normal dial tone, that
specific line (or any line) is not available for outgoing calls. This is because the
XLink has
not
been paired with a cell phone
or
the cell phone is
out
of
range.
11
To Next Page
Loading...
Need help?
General
