8
MANUAL BLUETOOTH CONNECTION
You
may
not
want
live calls
to
be transferred automatically
or
you may want
to
force
the
cell phone
to
disconnect from the XLink.
When a line
is
connected (blue
light
remains on) pressing
the
line
button
will disconnect
that
line and
the
light will turn
off
once disconnected. Audio will be transferred
to
the
cell
phone and you can continue your call on
the
cell phone.
When a line
is
not
connected and
not
searching (blue
light
remains off) pressing
the
line
button
will
put
the line
into
searching
mode
(blue
light
flashes slowly).
If
the
cell phone
has been previously paired and
is
within
range
the
cell phone will connect
with
the
XLink
and
the
blue
light
will remain solid.
o
NOTE:
• Some
cell
phones will promptyou when you come within range
of
the
XLink.
You
can
then decide
if
you want
to
transfer the
call
to
the XLink.
TESTING
THE
SETUP
After
connecting
one
or
more telephones
to
the
XLink,
the
setup test feature can be
used
to
ensure
proper
connections.
Ensure
the
green
light
is
on and
the
red
light
is
not
flashing.
2 Simultaneously press and hold
the
line 1 and line 2
buttons
for approximately
two
seconds: all telephones connected
to
the
XLink should start ringing.
QHINT:
•
If
an extension telephone does
not
ring, check
that
it
is
powered and
that
all
cables are properly connected.
To Next Page
Loading...
Need help?
General
