12
The MI-6 has 50 levels of sensitivity via the remote control.
Press or To adjust the sensitivity levels via the remote control.
For precise object location, low sensitivity levels, such as prog 1 and 2,
are recommended. The high sensitivity level (prog 3) is for cache location or
searching in walls and furniture.
The MI-6 audio PULSE tone can be adjusted from the remote control, tones range
from 120 to 1582 Hz. (Audio PULSE mode only).
Press or to adjust the tone.
Tone is available only with the Audio PULSE mode.
- Audio PITCH: The sound varies in tone and intensity, it is the default mode, it
oers fast target location.
- Audio PULSE: Has a higher sound, intended for noisy environments. Target
location is not as precise as PITCH mode. Pitch and Pulse mode both have the same
performance.
Choose from one of the 3 factory pre-set programs in the menu to make your
own custom program which can then be saved as (prg4).
Select the program you want by pressing or .
Enter the settings by pressing .
Save your settings by pressing .
When rst used the MI-6 will start on program 2. After this it will start on
the last used program.
The 4 programs on the remote control are separate from the programs
inside the pinpointer. When used independently the MI-6 (unpaired) will always
use it’s factory programs.
THE MI-6 - EXTENDED FUNCTIONS
Sensitivity
Tone
Audio PITCH / Audio PULSE
Making and saving a custom program
Press or to switch from one mode to another.
CONFIGURATION
TONE
AUDIO
SENS
CONFIGURATION
AUDIO
SENS
TONE 1582 HZ
CONFIGURATION
SENS
TONE
AUDIO PITCH
MENU
PRG 2
CONFIGURATION
TONE
AUDIO
SENS
OPTION
MENU
Retune At any time, you can re-calibrate the MI-6 by pressing the button very briey while away from
any metallic source. On mineralised soil and salt water, re-calibrate the MI-6 when in contact with the
ground to localize the detection range, also re-calibrate (de-tune) when near to a large object.
To Next Page
Loading...
Need help?
General