16
TROUBLESHOOTING
CAUSES SOLUTIONS
Sensitivity is too high.
You are in a zone with a lot of interference
(high-voltage power lines, electric transformer, electric fence).
There is a storm nearby and the electromagnetic
discharges of lightning are interfering with the detector.
You are close to other working metal detectors.
The ground balance is set too low. Reset it
The ground is heavily infested with iron and other metals.
Lower it (pg 05).
Lower the sensitivity change frequency/
frequency shift or move to a dierent zone.
Switch o and wait for the storm to pass
Change or shift the frequency (pg 05)
or move further away.
Adjust it (pg 08).
Find a less infested place.
Don’t practice in your garden!
The backphone is faulty.
The earpiece is faulty, for example its keypad was poorly
reconnected to the circuit after being removed, or the
audio contacts are faulty or dirty.
Change it, it is easy to replace (pg 17 ).
Contact your reseller
You become aware of abnormal performance, instability, false signals, interference, for no apparent reason
There is no sound in the headphones when passing over a target and pressing the buttons generates no audible beep
CAUSES SOLUTIONS
CAUSES SOLUTIONS
You have a dierent coil selected in the menu :
OPTION / COIL ON the remote control or in the menu
COIL on the headphones.
The serial number of the coil that you had entered in
the remote control was incorrect or was changed
inadvertently.
The coil battery is discharged
The coil is defective.
Select the corresponding coil (pg 10).
Check the coil’s serial number
(pg 10).paying attention to D & O
also B & 8.
Recharge it.
Contact your reseller.
The coil does not switch on, unlike the remote control and the headphones
To Next Page
Loading...
Need help?
General