Xplore ORX - ORX QUICK START; Switch on the remote.; Loudspeaker control.; Initialization wait.

Press to access the dierent features. Scroll through functions until SENSITIVITY .
Press to adjust the sentivity. Exit with .
Switch on the remote.
(
to switch o press for 2 sec)
Wait a few seconds.
Validate or not the use
of the loudspeaker.
By default factory program 1 - GOLD is selected
Press if you wish to select one of the 4 factory programs ( + 2 customisable programs).
ORX QUICK START
1- GOLD
27800 HZ
GND LEVEL
GND BALANCE GND MEASURE
15 cm
~
6
~
Press once to grab the
ground value while
pumping the coil to the
ground in order to calibrate
the ground eects.
Restart the operation if
the ground changes or
value becomes unstable.
lected
th 4f t (+2
t
Press to switch ON the WSA.
Press and to switch OFF the WSA.
*Note : The WSA will
turn OFF automaticaly with the remote.
Adjust the Sensitivity to stabilise the detector :
Change the audio volume with or .
Pairing the WSA to the remote control (page 10)