Xplore ORX - Automatic Mode; Manual Mode; Mode Salt

08
On the controller, press the “ Ground Balance” button once briey
while pumping the coil to the ground. The ORX will grab and calibrate
the current ground value and stabilise your ORX. The number on the
lower left of the screen (GND BALANCE) displays the users set
ground value.
Don’t keep the “Ground Balance” button pressed during this opera-
tion, just press it once during the pumping process.
If the ground is not eliminated well, follow the same procedure for a more
accurate calibration.
15 cm
~
6 inch
~
Restart the operation if the ground changes or it becomes unstable while searching.
1- GOLD
27800 HZ
GND LEVEL
GND BALANCE GND MEASURE
AUTOMATIC MODE
1- GOLD
27800 HZ
GND LEVEL
GND BALANCE GND MEASURE
You can manually adjust the ground rejection levels.
Note the right value (GND MEASURE)
By using adjust the GND BALANCE to correspond with
the GND MEASURE reading.
Each ground rejection level from 60 to 90 has additional units of ne tune
increments to allow for a better ground adjustment.
MANUAL MODE
GROUND
MODE SALT
On highly conductive soil ( salt lake or wet beach), activate the SALT MODE to
stabilise the ORX.
Press and hold for 2 seconds , to enable or disable the salt feature.
The ground balance range is now adjustable from 0 to 30.
1- GOLD
27800 HZ SALT
GND LEVEL
GND BALANCE GND MEASURE