26 FCC Notices Chapter 7 Agency Notices
RF Exposure
Tests for the Specific Absorption Rate (SAR) are conducted using standard operating positions
specified by the FCC with the tablet transmitting at its highest certified power level in all tested
frequency bands. Although the SAR is determined at the highest certified power level, the SAR
level of the tablet while operating can be well below the maximum value. This is because the
tablet is designed to operate at multiple power levels so as to use only the power required to
reach the network. In general, the closer you are to a wireless base station antenna, the lower
the power output.
Before a tablet model is available for sale to the public, it must be tested and certified to the FCC
and IC that it does not exceed the limit established by the government adopted requirement for
safe exposure. The tests are performed in positions and locations (next to body and lap) as
required by the FCC for each model. (Next-to-body and next-to-lap measurements can differ
among tablet models, depending on the available accessories, the FCC requirements, and the IC
requirements.) While there might be differences between the SAR levels of various tablets and
at various positions, they are all required to meet the government regulations for safe exposure.
This device was evaluated and shown to comply with FCC and IC SAR RF exposure requirements.
Avoid covering or holding antennas when transmitting. Antenna locations are shown in this
figure.
Antennas
WLAN
Bluetooth
Antenna
To Next Page
Loading...
Need help?
General
