27
970131
O 13x1.0
972030
O 3x2
HINT: Pre-thread the ball joint using an M3 screw.
WARNING! Be careful not to pre-thread too far, since the ball joint may split or the plastic threads may strip out.
INCORRECT
Fully extend the piston rod so the piston is at the
bottom of the shock body.
Hold the shock upright and slightly overfill the shock
body with shock oil.
Let the oil settle and allow air bubbles to rise to the
top. Slowly move the piston up and down to allow oil
into all cavities within the shock body.
Extend the piston rod most of the way out of the shock
body. Let the shock rest for 5 minutes to allow the air
bubbles to escape.
Add shock oil as necessary.
➊
➋
➌
➍
➎
SHOCK OIL
OIL 400cSt
SHOCK FILLING
CORRECT
#183011
HUDY RC SHOCK-PLIER UNI TOOL
HUDY SHOCK OILS (50ml)
#106310 100cSt
#106315 150cSt
#106320 200cSt
#106325 250cSt
#106330 300cSt
#106335 350cSt
#106340 400cSt
#106345 450cSt
#106350 500cSt
#106355 550cSt
#106360 600cSt
#106365 650cSt
#106370 700cSt
#106375 750cSt
#106380 800cSt
#106390 900cSt
#106410 1000cSt
#106420 2000cSt
50ml
INCLUDED
➊
➋
NOTE
ORIENTATION
After you insert the membrane, ensure
that it is fully seated inside the alu cap.
CUTAWAY VIEW
Foam insert
SHOCK OIL
SHOCK OIL
SHOCK OIL
SHOCK OIL
CUTAWAY VIEW
Be careful not to cross-thread the collar on the shock body.
To Next Page
Loading...
