XB9 TECH TIPS
TIP
TIP
Tighten screw until pivot ball
is tight against block.
Lift ball joint until it snaps into
place over pivot ball. Ball joint
should move freely.
The nished joint. Loosen and remove screw.
INSTALLING PIVOT BALLS INTO COMPOSITE BALL-JOINTS
Place the pivot ball on the ball joint
and use a screw to tighten it to an
engine mount or some other part.
TIP
GRAPHITE PARTS PROTECTION
TIP
Follow this tech tip to protect the graphite parts.
Fine sandpaper
Use ne sandpaper
to sand smooth the
edges of all graphite
parts.
Apply CA glue to all edges
of the graphite parts.
Protect all XB9
Graphite Parts:
• Front shock tower
• Rear shock tower
• Steering plate
To Next Page
Loading...
