EasyManuals Logo

XS Instruments 7 Vio User Manual

XS Instruments 7 Vio
33 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
32
Rev. 1.0 30.01.2020
EN
P9.1 Unit of measurement for temperature
Access this setup menu to select which temperature unit to use:
°C -default-
°F
P9.3 Backlight Mode
Access this setup menu to select the contrast mode to use for the display backlight:
INDOOR (In) – Default option - Recommended if you use the device indoors.
OUTDOOR (Out)Recommended if you use the device outdoors.
P9.4 Brightness
Access this setup menu to choose between three different levels of display brightness:
LOW
MEDIUM
HIGH
Note: Keeping the display bright always adversely affects battery life
P9.5 Sleep Mode
Access this setup menu to select whether and after how long activating the device Sleep mode:
OFF: Sleep mode off
2 MIN: The instrument enters Sleep mode if no key is pressed for 2 minutes.
5 MIN: The instrument enters Sleep mode if no key is pressed for 5 minutes.
When the device is in Sleep mode, the brightness of the display is reduced to a minimum, significantly saving
battery consumption.
To exit from the Sleep mode and return the display to normal brightness, press ANY button.
Once the display brightness is activated, the buttons reacquire their function (paragraph "Key function").
P9.6 Selection of the parameters
Function available for PC 7 Vio only
Through this setup menu, it is possible to select which parameters do NOT display in measure mode.
Access menu P9.6. The icon flashes, with the directional keys choose:
YES: in measure mode the pH parameter is kept active.
NO: in measure mode the pH parameter is not displayed.
Confirm the selection with key ; now the icon flashes, then repeat the same operation for the
mV parameter and then for all the parameters up to TDS .
Example: The user wishes to work with the pH, Conductivity and TDS parameters only.
In the P9.6 setup menu:
pH -> YES / mV -> NO / ORP -> NO / COND -> YES / TDS -> YES
Press key twice to return to measure mode. Scrolling with the key only the parameters pH,
COND and TDS are present.
Note: At least one of all the parameters must be enabled with YES.
P9.8 Reset Settings
Access this setup menu to restore the instrument to factory conditions.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the XS Instruments 7 Vio and is the answer not in the manual?

XS Instruments 7 Vio Specifications

General IconGeneral
BrandXS Instruments
Model7 Vio
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals