XS Instruments 7 Vio User Manual

31
Rev. 1.0 30.01.2020
EN
.
• Press again to access the TDS FACTOR P4.1 program.
• When the value flashes, use the directional keys as indicated by the icon to enter the correct value
and confirm with .
By default, the TDS factor is set at 0.71; the user can change it between 0.40 ... 1.00.
Here below, the TDS factors in relation to the Conductivity value are shown:
Conductivity of the Solution
TDS Factor
1-100 µS/cm
0.60
100 – 1000 µS/cm
0.71
1 – 10 mS/cm
0.81
10 – 200 mS/cm
0.94
The TDS measurement is expressed in mg/l or g/l depending on the value.
Instrument Setup menu
• In measure mode, press key to access the SETUP menu.
• Use the directional keys to move to SETTINGS P9.0 and access the menu by pressing the key .
• Move with the keys and to select the program to access.
The table below shows the setup menu structure for the general settings of the instrument; for each
program, there are the options that the user can choose and the default value:
• Composition of the setup menu for Setting Menu
Program
Description
Options
Factory Default
Settings
P9.1
TEMPERATURE U.M.
°C / °F
°C
P9.3
BACKLIGHT MODE
INDOOR – OUTDOOR
INDOOR
P9.4
BRIGHTNESS
LOW – NORMAL - HIGH
NORMAL
P9.5
SLEEP MODE
OFF – 2 MIN – 5 MIN
2 MIN
P9.6*
SELECT PARAMETER
YES – NO for each parameter
YES
P9.8
RESET
YES - NO
NO
P9.9
AUTO POWER-OFF
YES – NO
NO
* Function available for PC 7 Vio only

XS Instruments 7 Vio Specifications

General

Brand	XS Instruments
Model	7 Vio
Category	Measuring Instruments
Language	English