Xtender XTS 900-12 - Connection Compartment, XTS Model

56 pages

Save Page as PDF

To Next Page

To Previous Page

Studer Innotec SA

Xtender

User manual V4.6.0 13

3.6.3

Connection compartment, XTS model

Any unused cable entry on the device must be sealed to prevent any intrusion. An intrusion

of small animals in the unit may cause serious damage not covered by warranty.

Main Page

Default Chapter3
- Table of Contents3
1 Introduction5
2 General Information5
- Operating Instructions5
- Conventions6
- Quality and Warranty6
  - Exclusion of Warranty7
  - Exclusion of Liability7
- Warnings and Notes7
  - General7
  - Precautions When Using Batteries8
3 Assembly and Installation9
- Handling and Moving9
- Storage9
- Unpacking9
- Installation Site9
  - XTM and XTH9
- Fastening9
- Connections11
4 Cabling16
- Choice of System16
- Earthing System17
- Recommendations for Dimensioning the System18
- Wiring Diagrams19
- Connecting the Battery19
5 Xtender Parameter Settings24
- Basic Parameter Settings in the XTS24
6 Powering up the Installation25
- Connecting the Battery25
- Putting the Xtender(S) in Operation Using the Main ON/OFF Switch (1) if Present25
- Connecting the Consumers at the Output25
- Activating the Input Circuit Breaker(S) (H)25
7 Description of the Main Functions26
- Inverter26
  - Automatic Load Detection (Load Search)26
- Transfer Relay26
  - Type of Detection of AC Input Loss (UPS)27
  - Limiting the AC Input Current "Input Limit27
- Battery Charger28
- Xtender Protection30
- Auxiliary Contacts31
- Real Time Clock31
- Remote Entry (Remote Control On/Off)32
8 Multi-Unit Configuration33
- Three-Phase System34
- Increasing the Power by Paralleling Units34
- Combined System34
- Enlargement of an Existing Installation34
9 Accessories35
- Remote Control RCC-02/-0335
- BTS-01 Temperature Sensor36
  - Connecting the Temperature Sensor (BTS-01)36
- Remote Control Module RCM-10 (XTM/XTS)36
  - Connection of the RCM-10 Module36
- Time and Communication Module TCM-01(XTS)37
- Auxiliary Relay Module ARM-02 (XTS)37
- External Cooling Fan Unit ECF-01 (XTS)37
10 Other Xtender System Compatible Devices38
- Battery Status Processor BSP-500/-120038
- Communication Module Xcom-232I38
- MPPT Solar Charge Controller Variotrack/Variostring38
- Communication Sets Xcom-LAN/-GSM38
- Communication Module Xcom-SMS38
11 Control39
- Main On/Off Control39
- Display and Control Panel39
12 Maintenance of the Installation41
13 Product Recycling41
14 Ec Declaration of Conformity41
15 Comments to Drawings in the Appendix42
16 Drawing Elements (DC Side)44
17 Figure Elements (Ac Part)45
18 Mechanical Dimension and Mounting Elements46
19 Nameplate (Fig. 1B)46
20 Table of Factory Default Parameter Settings47
21 Technical Data54

Xtender XTS 900-12 - Connection Compartment, XTS Model

Table of Contents

Related product manuals