ACCESSORIES
1
FQFP Boards: Weld microcontrollers on
these boards to make jump wires more
easily. 5 different boards are fitted inside
the KC501 inventory, corresponding with
microcontrollers with different pins
(64/80/112/144/176).
When welding the microcontroller, please note thatt the white dot refers to
the pin 1. Do not weld the chip on the wrong direction.
2
EEPROM PCBA: Used for reading &
writing EEPROM chip on bench. Please
check “How to use – EEPROM reading &
writing” for more information on using this
PCBA.
3
EEPROM Chip Test Stand: A test stand to
hold EEPROM chip in place to read & write
EEPROM chip on bench. Please check
“How to use – EEPROM” for more
information on using this test stand.
To Next Page
Loading...
