Xtool Key & Chip KC501 User Manual

13
4) Via IC clip cable (no sealing-off required)
a. Switch the locker on the KC501 up to unlock the slot lock.
b. Insert the pin-side of the clip cable inside the slot.
Remember to recognize the pin 1 of the clip cable, which is
the wire that marked red. Make sure the red wire is heading
towards the bottom of the KC501.
c. Switch the locker down to hold the cable in place.
d. Use the clip and clip it on the corresponding EEPROM chip
firmly.
 This is only supported on small-sized EEPROM chips.

Xtool Key & Chip KC501 Specifications

General

Brand	Xtool
Model	Key & Chip KC501
Category	Motherboard
Language	English