To Next Page
Q
qwilsonAug 6, 2025
What to do if Xylem Goulds J cycles excessively?
- CCurtis WilliamsAug 6, 2025
If your Xylem Water Pump cycles excessively, examine the discharge piping and the house for any leaks.
What to do if Xylem Goulds J cycles excessively?
If your Xylem Water Pump cycles excessively, examine the discharge piping and the house for any leaks.
What to do if Xylem Goulds J Water Pump delivers water but will not shut off?
If your Xylem Water Pump delivers water but doesn't shut off, inspect the suction check or foot valve for any defects.
How to fix little or no liquid delivered by Xylem Goulds J Water Pump?
If your Xylem Water Pump delivers little or no liquid, ensure the pump is primed, that the suction pipe is adequately submerged, and that there are no air leaks in the suction pipe.
General| Brand | Xylem |
|---|---|
| Model | Goulds J Series |
| Category | Water Pump |
| Language | English |
Covers DANGER, WARNING, CAUTION, and NOTICE symbols for potential hazards.
Emphasizes reading safety instructions before wiring and following electrical codes.
Details jet pumps for maximum lift of 25', identified by one pipe to the well.
Explains convertible pumps for shallow (to 25') or deep wells (over 25') with jet assembly.
Describes deep well pumps for lifts greater than 25', requiring two pipes and specific jet assemblies.
Provides advice on piping materials, installation, and avoiding air traps in suction lines.
Instructions for installing suction pipes, foot valves, and check valves for shallow wells.
Steps for installing the shallow well adapter onto convertible pumps.
Procedure for connecting suction piping to the pump, emphasizing airtight connections.
Guidance on installing discharge piping, including tee/cross tee connections for tanks.
Details pipe sizes and recommendations for twin pipe suction systems in deep wells.
Steps for installing the jet assembly, venturi, and foot valve for twin pipe deep wells.
Instructions for suction piping in packer systems, including casing preparation and couplings.
Procedure for soaking, inserting, and sealing the packer assembly into the well casing.
Steps for connecting the suction pipe to the packer adapter at the well head.
Explains the need for back pressure and pressure control valves in deep well discharge lines.
Guidance on installing Goulds Water Technology HydroPro water system tanks.
Detailed procedure for priming shallow well jet pumps, including venting.
Instructions for priming deep well jet pumps, emphasizing complete prime before operation.
Instructions for changing motor voltage using the voltage plug and terminal board.
Referencing diagrams for plumbing booster systems from city water or cisterns.
Details on changing motor voltage via terminal board and voltage plug.
Explanation on how tailpipes prevent loss of prime in deep well jet pumps.
Guide on using a vacuum gauge to measure suction lift and interpret readings.
Lists common pump symptoms and their probable causes for diagnosis.
