90
1100
1100 SUBMENU SETUP
1110
1110 FACTORY SET
EUROPE
Restores the HV to factory setting
Possible settings: EUROPE, USA
To restore the HYDROVAR to factory settings select Europe or USA.
For reset press ► button till DONE appears.
1120
1120 PASSWORD 2
0000
Enter password by pressing ▲ or ▼
The below mentioned parameters are available after entering the right password!
For more information, pls. contact your local distributor!
1125
1125 CLR ERRORS
UNIT X
Clear error memory of selected unit
or on ALL units (Cascade Serial/Synchron)
Possible settings: 1 – 8, ALL
To clear the error memory either (1-8) for one specific unit or ALL for all units, can be
selected.
For reset press ► button till RESET appears.
1130
1130 CLR MOTORH.
UNIT X
Clear motor hours for selected unit
or on ALL (Cascade Serial/Synchron)
Possible settings: 1 – 8, ALL
Set desired unit where the Motor Hours should be cleared (or ALL) and press ► button till
RESET appears.
1135
1135 CLR OPERAT.
Press ► 3 sec.
Clear operation time
The operation time indicates the total time the HYDROVAR is already connected to power
supply. For reset the operation time of the current HYDROVAR press
► button till RESET
appears.
To Next Page
Loading...
Need help?
General
