Heat / Cooling meter integrator PolluTherm
Installation and operation instructions
M H 6111 INT PolluTherm, page 13
By connecting the two additional wires for each
temperature sensor at the terminal block of the
integrator, i.e. for the higher temperature 1 and 2
and for the lower 3 and 4, the electric resistance
of the extension cable or cables does/do not
influence the measurement and the reading of the
temperatures.
Material number: 28505033
Edition: 007 - August 2019
Subject to change without prior notice
Sensus GmbH Ludwigshafen
Industriestraße 16
D-67063 Ludwigshafen
Phone: + 49 (0) 621 6904-1113
Fax: + 49 (0) 621 6904-1409
E-Mail: info.de.sensus@xyleminc.com
Qualitätsmanagementsystem Quality Austria-zertifiziert
Nach ISO 9001, Reg.-Nr. 3496/0
To Next Page
Loading...
Need help?
General
