STARTING PROJECTOR
Turn on the projector
Hang ceiling:
Please purchase the projector stand and M5 screw additionally.
Install the projector stand to place ①, and hang the projector on the ceiling.
( Note: You can install the Tripod Stand to the place ① )
1.Install two AAA batteries in the remote control before using.
2.Press the Power key on the remote or panel, the indicator light will turn red.
3.Remove the lens cover of the projector, the lamp will start working 2 seconds
later, when an image is projected on the screen the machine is working
smoothly. If the first projection screen is not the start up screen, press the "S"
button on the remote and select USB source.
4.Adjust the keystone ring to get a rectangle shape.
5.Adjust the focus ring or rotate the lens of the projector to get the best image
performance. (If it is still blurry, please try to adjust the projection distance.)
6.If you connect other devices, be sure to select the corresponding source. If
you do not select the correct source, the projector will not be able to detect the
signal.
7.P re ss the Menu button on the remote control to enter the OSD Language to
set your preferred language;
①
support01@yaberauto.com
EN
17
To Next Page
Loading...
Need help?
General
