Yaesu WIRES-X FTM-300D User Manual

Wide-Coverage Internet Repeater Enhancement System
WIRES-X Portable Digital Node Function
Instruction Manual
The C4FM digital transceivers that support the Portable Digital Node Function are
FT3D, FT2D, FTM-400XD/D, FTM-100D and FTM-300D. (As of May 2020)
Other C4FM digital transceivers do not require WIRES-X user registration and may
immediately enjoy Internet communications by connecting to a WIRES-X local node
that is within radio range.

Yaesu WIRES-X FTM-300D Specifications

General

Brand	Yaesu
Model	WIRES-X FTM-300D
Category	Repeater
Language	English

Summary

Preparation Procedure

User Registration

Acquire a unique WIRES-X ID number for node operation.

Install WIRES-X Software and Drivers

Download and install the WIRES-X software and necessary PC drivers.

Update Transceiver Firmware

Connect Transceiver and PC

Establish the physical connection between the transceiver and the PC.

System Requirements

Initial Setup and Configuration

WIRES-X Software and Port Settings

WIRES-X Server Authentication

Activate your WIRES-X account and server connection.

Transceiver Settings for Access Point

Basic Operation Modes

Portable Digital Node Mode

Connect and operate in C4FM digital mode using the node.

Portable HRI Mode

Connecting to Internet Resources

Connecting via WIRES-X Software Interface

Connecting via Transceiver Interface

Communication and Disconnection

Communicating with Other Stations

How to send and receive audio and data during a connection.