Need help?Do you have a question about the Yaesu Wires-X and is the answer not in the manual?
General| Type | Digital Voice Repeater |
|---|---|
| Operating Modes | FM, C4FM |
| Modulation | FM, 4FSK (C4FM) |
| Digital Voice Support | Yes (System Fusion) |
| Network Connectivity | Internet |
| Compatible Protocols | Wires-X |
| Interface | PC connection via USB |
| Supported Nodes | Digital Node / HRI-200 |
Explains the WIRES (Wide-coverage Internet Repeater Enhancement System) for amateur radio communication.
Describes the function of operating a WIRES-X digital node station by connecting a transceiver to a PC.
Lists the necessary hardware and software for Portable Digital Node operation.
Steps to register for a WIRES-X ID number on the official website.
Guide to download and install the WIRES-X software on your computer.
Instructions for installing the necessary USB driver for PC connection.
Steps to ensure the transceiver has the latest firmware version installed.
Instructions for physically connecting the transceiver to the PC.
How to power on the transceiver in specific modes for setup.
Steps to launch the WIRES-X application on the PC.
Configuring the COM port for PC-transceiver communication.
Process for activating the WIRES-X server using Node ID and Room ID.
Configuring transceiver parameters for Access Point mode operation.
Guide to operating the transceiver in the Portable Digital Node Mode.
Guide to operating the transceiver in the Portable HRI Mode.
Adjusting PC audio levels for HRI Mode communication.
Specific functions for analog audio in FT2D Direct Operation.
Settings for transceiver screen display and lamp control in HRI Mode.
To Next Page