Yale Conexis L1 - Pairing to a Smart Home Controller

Pairing To A Smart Home Controller
•
26
Remove From Controller
The lock may need to be removed from a home automation
system before being added to a new system. To do this,
please carry out the following:
1. Put the existing system into the ‘Device Exclusion Mode’
2. Press ‘R’ button 3 times within 1.5 seconds
3
2
1
4
Pairing is a two way process,
your smart home controller may
need to be in ‘Device Inclusion
Mode’
5
Press ‘R’ 3 times within 1.5 sec
Having diculty? Please check out our video guides.
Insert
radio
module