15
Handing The Lock
1
2
3
Hold ‘R’ Button for 15sec until
“Beep Beep”
Return handle to centre
Return handle to centre. The
lock will now configure itself
by locking and unlocking.
If these steps are not completed the door will not lock.
If the lock sounds like it is struggling to lock, check actuator
installation shown on page 8
If after completing this step
you get 8 related beeps and a
red light, this indicates there
is an issue with alignment.
To fix this please uninstall the
unit & go back to page 8.
“Beep Beep”
“Beep Beep Beep”
To Next Page
Loading...
Need help?
General