1.7 Installation of threaded pull tube,
positioning plug and transmission plate
1.9 Door holes opening
1.8 Main body handle cover removal
Lock body hole template
screw hole
Mortise hole-opening template
Threaded pull tube
Threaded pull tube
Threaded pull tube
Positioning plug
Cotter pin
Transmission plate
Gasket
1
2
Step 1. Insert transmission plate
Step 2. Bend the cotter pin with a tool to secure the transmission plate.
Step 3. Cut the positioning plug to the required length according to Table 1.2.1 in section 1.2
11 12
Before installation, use a flat-headed screw driver to detach the handle cover on
the main body as shown in the picture above to expose the screw holes for
installation later.
Bore holes on the door using the installation template. Do not close the door
during the installation of the product.
To Next Page
Loading...
