2. For TBS, apply lubricant to
the needle valve and the valve
hole that will be used (see
NOTE in Step 1), by inserting
and removing the lubricated
valve several times. If a three-
or four-piece wheel is being
used, remove the valve. If a
two-piece wheel is being used,
leave valve in valve hole.
If the TBS has two valve holes, lubricate the plastic plug and
insert into valve hole that will not be used.
3. Place the TBS or TSR rub-
ber sealing ring inside the tire,
making sure the wings are not
folded over. For the TBS rub-
ber sealing ring, with separate
valve stem, make a mark on
the tire to note the position of
the valve hole. For TSR rubber
sealing ring with an integral
valve stem, align valve slot in
the rim with the TSR valve stem.
4. Apply lubricant to the rim. If a four-piece wheel is being
used, lubricate the advance band. Slide the tire and rubber
sealing ring onto the wheel.
For TSR, use a lever to push
the valve stem through the
valve slot in the wheel. For
TBS tires, line up the valve
hole in the TBS with the valve
slot in the wheel. Lubricate and
insert the valve into the valve
hole. Make sure it is fully inser-
ted.
Maintenance
186
To Next Page
Loading...
Need help?
General
