Need help?Do you have a question about the Yamaha CR1020 and is the answer not in the manual?
General| Type | Stereo Receiver |
|---|---|
| Manufacturer | Yamaha |
| Model | CR1020 |
| Power Output | 70 watts per channel into 8Ω (stereo) |
| Total Harmonic Distortion | 0.1% |
| Year | 1977 |
| Tuning range | FM, MW |
| Frequency Response | 20Hz to 20kHz |
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Signal to Noise Ratio | 90dB (line) |
| Speaker Load Impedance | 8 Ohms |
| Damping Factor | 60 |
| Dimensions | 523 x 168 x 355mm |
Instructions for connecting FM antennas, including types and placement.
Step-by-step guide for preparing and connecting coaxial cable.
Guidance on using the built-in bar antenna and connecting external AM antennas.
Guidelines on speaker impedance, power handling, and connection.
Detailed steps for physically connecting speaker wires to terminals.
Information on connecting and using headphones with the receiver.
Instructions for connecting a turntable and setting up for record playback.
Explanation of simultaneous listening and recording functions.
Details on using the PRE OUT/MAIN IN coupler for separate component operation.
How to connect tape decks for playback and set input selectors.
How to connect tape decks for recording and use the REC OUT selector.
Explanation of bass, treble, and presence tone controls.
Details on bass and treble control turnover frequencies and their effect.
Focuses on the mid-range presence control for tonal character.
Overview of low and high frequency filter functions and their steep cut-off.
Practical advice on using low and high filters for rumble and hiss reduction.
Explanation of the mode switch for stereo, mono, and channel selection.
Troubleshooting common audio issues like no power, no sound, and balance problems.
Troubleshooting common tuner issues like hum, crackling, and reception problems.
To Next Page
