Yamaha CRX-E150 - Getting Started: System Connections; Connecting Speakers and Antennas

6
Connecting the speakers
Never plug the AC power cord to the wall outlet until all connections are
completed.
Follow the steps as shown below to connect the system using the supplied cords and accessories.
1 Connect the Speakers.
1 Unscrew the knob.
2 Remove approx. 10 mm (3/8”) of insulation from
each of the speaker wires and insert the bare wire
into the terminal.
3 Tighten the knob to secure the wire.
2 Connect the AM Antenna.
Set up the AM loop antenna, then connect it.
3 Connect the FM Antenna.
4 Connect the AC power cord to a wall outlet.
Notes
• Use external FM/AM antennas if you need better reception.
Consult your dealer.
• The AM loop antenna should be placed apart from the main
unit. The antenna may be hung on a wall.
To Connect the Subwoofer (optional)
You can reinforce the bass frequencies by adding a
subwoofer (optional).
Connect the SUBWOOFER OUT terminal of the unit to
the INPUT terminal of the subwoofer.
1
3
FM antenna
2 AM loop antenna
Right speaker
Left speaker
GETTING STARTED
Red: positive(+)
Black: negative(–)
GND AM ANT
1
2
3
MD
TAPE
IN
OUT
IN
IN
OUT
AUX
D
A
B
L
R
C
SYSTEM CONNECTOR
OUT
SUBWOOFER
OUT
DIGITAL
OPTICAL
＋
−
SPEAKERS
RL
6 Ω MIN. /SPEAKER
CLASS 2 WIRING
FM ANT
GND – AM ANT
75 Ω UNBAL.
4 To wall outlet
FM ANT
75 Ω UNBAL
(U.S.A. model)